![]() I realize I have not provided a whole lot of details here, but since I an not getting any error message outside of when I try to run the chown command, i am not sure what else to do. I will configure my servers, etc, in the config file and see if I can at least get it fully running in console by monitoring watched folders, but I sure would love to get that web gui working, just like old times. We will explain some of the basic concepts and limitations, and then we'll provide you with common examples. I am not sure where to begin troubleshooting since the application seems to at least load, just not in the browser. The goal of this guide is to give you ideas on what can be accomplished with the LinuxServer SWAG docker image and to get you started. After some digging, I saw a post stating this issue was fixed in 21.1-testing-r2311, which I installed but still no luck. Running the command does bring up the ncurses display, but if I go to in the browser, I get nothing. Im running NZBGet v21 on macOS Big Sur Version 11.0.1. I configured the nf file to set up my paths and copied the config file to ~/.nzbget This was after failing with the instructions in the Arch WIki and running nzbget -s from commandline. ![]() ERROR Binding socket failed for 0.0.0.0: ErrNo 98, Address already in use. Notice the last line, connection is refused on the webserver for some reason. Heres a pastebin of console output from commands. The logical side of me says I should probably create the user and group, but the instructions do no say to do so, and I don't recall having to do this in other distributions to get the application working. I wiped all the config files and purged nzbget, then documented the process of installation and configuration. Im connecting 2 clients and then disconnecting them with close() before I shut down the server, I also then quit the clients before opening the server just in case, however it still seems to fail and I have to restart my computer. The portion of the instructions regarding chown to set permissons does not work because the user and group nzbget does not exit. Ive been writing a server and every time I quit it and re-open it, it seems to fail to bind to the socket. Needless to say it installed just fine with pacman. If you are trying to be accessible from the outside, its best you subcribe to a DynDNS service as you have a non static IP, so you can always be reached even when your IP changed. This restores the old NZBGet behaviour (v18 and older) but you should know that your connection is insecure and you might be connecting to attacker’s server without your awareness. I'm trying to follow along with the arch wiki for nzbget installation. However, you can set up your router to forward incoming requests on a certain port to your machines local IP. A quick fix on your side is to disable certificate verification (CertCheckno).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |